- #Ricardo villalobos alcachofa rar how to
- #Ricardo villalobos alcachofa rar install
- #Ricardo villalobos alcachofa rar software
Task 1 – Run ProjectZero project The first task is to simply run the Project Zero example project on the CC2640R2 LaunchPad and verify that the project runs as intended.
#Ricardo villalobos alcachofa rar install
BTool accessible via the tools->blestack->btool directory of the SimpleLink CC2640R2 SDK install directory. The SimpleLink CC2640R2 SDK at C: ti simplelink_cc2640r2_sdk_1_50_00_xx. These instructions assume you have installed to the default directory: C: ti This gives you: Run the SimpleLink CC2640R2 SDK installer: simplelink_cc2640r2_sdk_1_50_00_xx.exe. #Ricardo villalobos alcachofa rar software
Getting started – Desktop Install the software. Mobile device for testing Recommended reading. Additional CC26xx LaunchPad to run host_test OR. Refer to the chapter of the TI BLE-Stack User's Guide for the procedure to install other compiler versions. Compatibility with other TI ARM Compiler versions in CCS has not been tested and use of other compiler versions may result in undefined behavior. Compiler Support See SimpleLink CC2640R2 SDK Release notes for supported TI ARM Compiler versions. iOS: LightBlue Explorer - Bluetooth Low Energy by Punch Through - available on the. Android: BLE Scanner by Bluepixel Technology LLP - available on the. 
BTool (located in tools->blestack directory of the SimpleLink CC2640R2 SDK installation) OR. For testing, a Bluetooth client application is required:. installed with support for CC13xx/CC26xx devices. Prerequisites Software for desktop development Some references will also be made to this document. It is recommended to read the alongside this lab for details and further information. The advantage of using host_test is that the TI tools, such as BTool, can be used. For the latter tasks, either a Bluetooth low energy enabled cell-phone or an evaluation kit running the TI host_test Sample Application is required. #Ricardo villalobos alcachofa rar how to
The first task shows how to download a project to the device and run it, and the subsequent tasks will explore the wireless BLE interface and make some small changes to the BLE application. This lab session uses the SimpleLink Bluetooth low energy CC2640R2F wireless MCU LaunchPad development kit to demonstrate the tasks in this module. There should be an intermediate level of knowledge of the C programming language as well experience with embedded software development to be able to complete the tasks. Introduction This workshop is an introduction to the SimpleLink™ Bluetooth® low energy CC2640R2 software development kit (SDK) The 4 tasks in this lab session are targeted to be completed within a 2h time frame.
0 kommentar(er)
